Aluminium Venetians 25mm

MATERIAL & SIZES

Aluminium 25mm slat only
0.21mm thickness

STANDARD OPERATING SYSTEM

Cord operation including cord lock, with wand tilter

Limitation

• Maximum width : 3010mm
• Maximum drop : 3200mm
• Minimum width : 300mm
• Minimum drop : 300mm
• Single Blind size should not exceed 9m2
• Any blind over 9m2 will be made as a 2-ON-1 head-rail with a maximum width of 3010mm

HEAD-RAIL

23.8 x 24.8mm aluminium head-rail

BOTTOM-RAIL

10 x 19mm C type bottom-rail

CORD LENGTHS

• Standard Factory calculation is 2/3rds of the drop of the blind drop
• Child Safety Breakaway is located approx. 100mm from the cordlock.

2-ON-1 HEAD-RAIL BLIND OPERATION

Number of ladders & pull cords, please refer to chart.
For tilt & lift option, cords cannot be in the middle of the blind.
Cords can be located :
both left, both right, left/right (nominate tilt & lift for corded both sides)

MULTIPLE BLINDS ON ONE HEAD-RAIL (2-ON-1)

All blinds over 9m2 will be available in 2-ON-1.
This helps eliminate problems inherent in excessively large blinds plus gives the benefits of easier liftingand flexibility with tilting.
Max width for 2-ON-1 blinds (surcharge applies) is 3000mm, max drop is 3200mm.
The blinds will have dual cord lift and tilt controls (independent control). Centre gap between the blinds is approx 4mm.

HOW TO CALCULATE A DROP MEASUREMENT

Our standard drop measurement is achieved when blinds are in the closed position and the bottom-rail tilted. When the blind is in the open position, the lowest point of the bottom-rail will sit around 10mm higher than when the blind is in the closed position.

STANDARD TOLERANCE

Please note that our standard tolerance for blind width and blind drop is +/-5mm. If the blind is made within our tolerance range, no claim will be accepted.

LIGHT BLEED

All blinds allow light to pass around the sides of the blind. In addition there will be small pin holes of light in each slat where the ladder cords pass through. Consider using face fit as an option rather than reveal fit to reduce light bleed at the sides. This is not a blockout product.

LARGER SIZES

As a guide, Aluminium blinds over 9m2 will be heavy to lift up. Depending on the application, it is advised to use two or more blinds instead of one. When lifting larger blinds, the operator should guide the blind by holding the base-rail as they are lifting it up.

CUTOUTS

A cutout is a blind with an area removed from it to avoid an existing obstruction. Please provide detailed measurements of the area to be removed. Maximum Depth Of Cut Out is 110mm per side. Surcharges apply, please refer to “Surcharge & Option” list.

CLEANING 

Damp cloth, lightly vacuum (with appropriate attachment)